We supply cooling towers. Our Industrial Bottle Shaped Cooling Tower is available for buyers in Kurigram who need a cooling system matched to their process and site. We review the heat load and water flow before discussing tower size. A larger tower isn't always the right answer.
We check the duty. If hot water enters at 37°C and the process needs it back at 32°C, we also need the water flow rate and site wet-bulb temperature before we can assess the requirement. The temperature gap alone won't set the size.
Sun affects FRP. We select materials with outdoor exposure in mind, since sunlight and rain can affect the outer surface over time. The resin and finish matter, as does the upkeep of the tower (especially on exposed roof sites). Surface checks should be part of routine maintenance.
Water needs attention too. We look at the water distribution system and fill access when discussing a tower, as scale and dirt can restrict water flow and reduce heat transfer. A clean outer shell won't tell the full story.
We consider site conditions. Strong wind, dust and limited access can affect where a tower is placed and how the team carries out cleaning. We ask for the proposed layout before settling on the design. Access matters later.
Our scope has grown. Since starting in 2022, we have built our work around complete cooling towers and the parts needed to support them. This includes fills, nozzles, fans and motors for new systems or replacement work. The duty comes first.
We review each requirement. Our design process covers material selection, airflow, water distribution and structural strength, followed by controlled fabrication and functional testing. For an existing setup, we need equipment details and site limits before deciding whether a replacement tower or component is suitable. Guesswork causes delays.
Space can be tight. We can discuss changes based on capacity and site constraints, but the final layout depends on airflow clearance, pipe connections and room for maintenance (fan access is often missed). We check these points before taking the design forward.
Parts need a match. When a buyer needs a replacement fan, fill or sprinkler, we ask for the existing dimensions and operating details rather than relying on the tower name alone. The same tower shape can have different internal arrangements. Fit needs checking.
We plan for maintenance. The team operating the tower should be able to inspect the fill and water distribution parts without major dismantling, subject to the final layout. We can review these access needs during the enquiry. Early input helps.
Send us the details. Buyers in Kurigram can share the cooling duty, available space and expected operating hours with our team. We can then review the request and discuss the next steps. Drawings or equipment photos are useful.